Key takeaways
-
Verification checks the balance against a known weight. Adjustment corrects it. Calibration is the documented comparison against traceable standards.
- A quick daily check with one test weight catches most problems before they affect results.
- Choose test weights by your balance's readability: E2/F1 for analytical balances, F1/F2 for precision balances, M1 for industrial scales.
Calibration, adjustment, verification: what's the difference?
| Term |
What it means |
Who does it |
| Verification (check) |
Weigh a known test weight and confirm the reading is within tolerance |
Lab staff, daily or before use |
| Adjustment |
Correct the balance so it reads properly, using internal or external weights |
Lab staff (internal) or a technician |
| Calibration |
Documented measurement of errors against traceable standards, with a certificate |
An accredited calibration provider, usually once a year |
A 5-minute daily routine
-
Check the level bubble and re-level if needed. Moving a balance even slightly can shift it.
-
Warm up: leave the balance powered on (many labs leave analytical balances on permanently).
-
Run internal adjustment if your balance has it, especially after temperature changes.
-
Sensitivity check: weigh a test weight near the top of your usual weighing range and record the result.
-
Compare to your tolerance and take the balance out of use if it fails.
Less often (weekly or monthly), add repeatability (weigh the same weight several times), eccentricity (place the weight at the corners of the pan) and linearity (check at several points across the range). Regulated labs such as pharmaceutical QC follow their own standards, for example USP general chapters <41> and <1251>, for test frequency and acceptance criteria.
Which test-weight class do you need?
Higher classes (E1 is the highest) have tighter tolerances. Always buy weights with a traceable calibration certificate, handle them with tweezers or gloves, and store them in their case.
Internal vs. external adjustment
Balances with internal calibration have a built-in motorized weight and can adjust themselves automatically on a schedule or after temperature changes. Balances with external calibration rely on you placing a certified weight. Internal calibration is more convenient, but you still need external test weights to verify the balance independently.
When to call for a full calibration
- On a fixed schedule (most labs do it once a year) and whenever your quality system requires
- After the balance is moved, repaired or dropped
- When a daily check fails and adjustment doesn't fix it
- Before audits, or when starting a new regulated method
Frequently asked questions
Can I use one weight to check all my balances?
Only if its class and value suit each balance. An M1 weight is not accurate enough to check a 0.1 mg analytical balance.
How often should test weights themselves be recalibrated?
Commonly every 1–2 years, depending on use, class and your quality system. Weights that are dropped or contaminated should be recalibrated immediately.
Why does my balance drift during the day?
The usual causes are temperature changes, drafts, vibration, static electricity or an unlevel bench. Check the environment before suspecting the balance.
Need weights or a new balance?
Tell us your balance model and readability, and we'll recommend the right weight class and set.
Request a Quote
Shop: Calibration Weights · Laboratory Balances · Weighing Accessories · Read next: Buying an Analytical Balance
Comments (0)